Now that everything is in the case and the control buttons are wired up it’s time to look at providing power to motors and get things turning. Before I rush into that though it’s time to correct and oversight.

The mounting panel now sports all the parts that will go into the case (except the PMDX, but the standoffs are in) so I moved on to fitting the various buttons, lights and dials to the cabinet door.

With the basic circuit checked and holes drilled for everything that would mount to the panel it was time to get the panel into the case.

Now that I had the power supply cornered and exactly where I wanted it it was time to mount the other components on the panel.

With the power supply frame completed I moved onto the mounting plate.

Now that I had a layout it was time to start the build and the first thing I did was change part of the plan…

I’ve received most of the electrical parts now so it’s time to start the build. The first thing to do is a dry run laying them out in the case. Before I get into laying out the parts though here’s…

There comes a time in every project when you have to just get a grip and get on with it and damn the consequences and I think I’ve got to that stage with the electrical part of this build. I’m…

Limit switches or sensors are not absolutely required on a machine, it will work just fine without, but they are a very good addition as they prevent potentially expensive and dangerous crashes. There are three levels of safety when it…

I always knew that the electrical side of this project would be difficult but I hadn’t realised quite how difficult it would be. With the mechanical aspects of the build at least you can look at either the part or…