-
With the inrush / soft start designed and most of the parts ordered my mind turned to the other components I’m going to need to finish the case.
-
Yeti – Electrical build Part 9
In part eight I discussed the problem with inrush into the power supply and some potential solutions. In this part I’ll show the actual solution I’ll be using.
-
Yeti – Electrical Build Part 8
I’ve got to the point where I have a stepper motor turning but I’m hesitant to move forward until I have the inrush issue fixed with the power supply.
-
Yeti – Electrical Build Part 7
Now that everything is in the case and the control buttons are wired up it’s time to look at providing power to motors and get things turning. Before I rush into that though it’s time to correct and oversight.
-
Yeti – Electrical Build Part 6
The mounting panel now sports all the parts that will go into the case (except the PMDX, but the standoffs are in) so I moved on to fitting the various buttons, lights and dials to the cabinet door.
-
Yeti – Electrical Build Part 5
With the basic circuit checked and holes drilled for everything that would mount to the panel it was time to get the panel into the case.
-
Yeti – Electrical Build Part 4
Now that I had the power supply cornered and exactly where I wanted it it was time to mount the other components on the panel.
-
Yeti – Electrical Build Part 3
With the power supply frame completed I moved onto the mounting plate.
-
Yeti – Electrical Build Part 2
Now that I had a layout it was time to start the build and the first thing I did was change part of the plan…
-
Yeti – Electrical Build Part 1
I’ve received most of the electrical parts now so it’s time to start the build. The first thing to do is a dry run laying them out in the case.
-
Yeti – Electrical Design Part 3
There comes a time in every project when you have to just get a grip and get on with it and damn the consequences and I think I’ve got to that stage with the electrical part of this build. I’m…
-
Yeti – Electrical Design Part 2
I’ve been reading everything I can get my hands on regarding the electrical design for this machine but I’m still most stumbling around in the dark. Everyone else seems to find is trivially easy and I suppose in some ways…
-
Yeti – Limit Sensors
Limit switches or sensors are not absolutely required on a machine, it will work just fine without, but they are a very good addition as they prevent potentially expensive and dangerous crashes. There are three levels of safety when it…
-
Yeti – Electrical Design Part 1
I always knew that the electrical side of this project would be difficult but I hadn’t realized quite how difficult it would be. With the mechanical aspects of the build at least you can look at either the part or…
-
Yeti – Component Purchase
Since the last article all the way back in September the build hasn’t move very far forward but I thought it was time for an update as a few interesting things happened in the last couple of days. My main…